167.net必赢(中国)官方网站·App Store

中文资料（谷歌翻译）


Carprog Full v9.31 ECU芯片工具
编号：CTE019

CARPROG FULL V9.31（大多数软件被激活，所有21个适配器）是针对客户的要求而设计的，具有用于汽车收音机，里程表，仪表板，固定器修复的通用工具，包括EEPROM和微控制器编程器等高级功能，钥匙转发器程序员。

功能：
1.使通用工具 - 内部的CARPROG具有强大的16位MPU和全套汽车接口驱动程序。在基本版本中，您将获得具有额外功能的硬件：用于EEPROM在线编程器的12个输入/输出引脚，将来可能在同一个硬件上进行微控制器编程器，不间断应答器具有125/134 kHz天线适配器的关键编程器，K线诊断（仪表里程表编程，防盗键编程），CAN线路诊断，+ 5V / + 12V输出，USB，仅USB供电。
2.制作低成本工具 - 使用CARPROG基本功能，您将收到许多额外功能（如CAN无线电代码计算器CC1，EEPROM编程器和V仪表板编程器），所有其他软件可根据需要额外购买。
3.使用户友好 - Windows XP软件，无需任何安装，在所有PC上，使用USB到PC链接，所有适配器原理图在线。

CARPROG FULL V9.31软件：
> ECU-OPEL - 电机混合动力ECU的OPEL登录阅读器。适用于ME1.5.5，Siemens SIMTEC71，SIMTEC71.1，Delco Diesel，Delco Multec。
> OPEL CAN - CAN编程器的欧宝ECU - EDC16，MT35E，HSFI 2.2读取/更改里程读取PIN，复位ECU
> PSG16 - 欧宝PSG16柴油泵由OBDII - 读/换里程，读PIN，复位ECU
> OPEC28 - 欧宝西门子Simtec ECU工具高级
CarProg适配器：

Carprog Full v9.31 ECU chip tool
ID NO:CTE019

CARPROG FULL V9.31 (with most Software is activated and all 21 items Adapters), was designed with regard to demands of our customers to have universal tool for car radios, odometers, dashboards, immobilizers repair including advanced functions like EEPROM and microcontroller programmer, key transponder programmer.

Functions:
1. Make the Universal tool - CARPROG inside have powerful 16-bit MPU and full set of automotive interface drivers. In basic version you will get hardware with extra functions: 12 input/output pins for EEPROM in-circuit programmer, future possibility's to make on the same hardware Microcontroller programmer, Immobilizer Transponder Key programmer with antenna adapter for 125/134 kHz, K-line diagnostic (dashboard odometer programming, immobilizer key programming), CAN line diagnostic,+5V/+12V output, USB, power supply only from USB.
2. Make the Low Cost tool - with CARPROG basic you will receive many extra functions (like car radio code calculator CC1, EEPROM programmer and V dashboard's programmer by CAN) and all additional software's you can buy extra according your need.
3. Make it User Friendly - Windows XP software, works without any installations, on all PC, use USB to PC link, all adapters schematics diagrams on-line.

CARPROG FULL V9.31 Softwares:
>ECU-OPEL - OPEL login reader from motor hybrid ECU. Works with ME1.5.5, Siemens SIMTEC71, SIMTEC71.1, Delco Diesel, Delco Multec.
>OPEL CAN - Opel ECU by CAN programmer - read/change mileage in EDC16, MT35E, HSFI 2.2 read PIN, reset ECU
>PSG16 - Opel PSG16 diesel pump by OBDII - read/change mileage, read PIN, reset ECU
>OPEC28 - Opel Siemens Simtec ECU Tool Advanced